Xerox phaser 7760dn driver4/6/2024 ![]() I'm nervous about installing the newer firmware as 1. There is a new firmware and driver available (although the driver is 4 years old) which refer to 'SRA3 margin problem' - I've installed the driver (for which there's only a Win2K version, 32bit and I'm on Win7 64 bit!) but the margin settings reported by the driver are the same as before. I've got an outstanding call with Xerox but I wondered if anyone here had any ideas? Is it a product limitation? If so, I can't find ANY specs on the internet refering to this. By turning the margins to 'none' (in advanced section of driver) I've managed to get it to print 301mm but this still isn't good enough. It'll quite happily feed SRA3 but for ages I couldn't get it to print wider than 297mm. BUT I've got big problems with the print width. We've just bought a 7760 to give us a better print quality. We print an image 305mm wide to give us enough bleed so it will cut on our Morgana CardXtra without leaving white marks. I've been running a Phaser 7400 on SRA3 stock for a couple of years. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |